- 1. In a Cisco router, the primary interface used for its initial configuration would be its _______________________ interface.
A) Ethernet
B) AUX
C) console
D) Serial
- 2. A reason why fiber would be preferable over copper cabling would be that with fiber offers _________________ distances of data transfer can be obtained per cable run.
A) equal
B) lesser
C) greater
D) distinct
- 3. A reason why fiber would be preferable over copper cabling would be that with fiber is ____________ susceptible to Electro-magnetic interference.
A) distinctly
B) more
C) equally
D) less
- 4. You are advised you are on a limited budget, your cabling distances are limited and you cannot purchase repeaters. Would type of cabling would you use?
A) multi-mode fiber
B) single-mode fiber
C) STP
D) UTP
- 5. Attenuation occurs in data transfers which use longer cabling that what ANSI specifies. Attenuation in other words is the loss of signal strength as the ________________ increases.
A) domains
B) servers
C) distance
D) fast-Ethernet ports
- 6. You are given the IP 130.68.0.0 with a subnet mask of 255.255.248.0. How many host addresses do you have per subnet?
A) 4094
B) 4
C) 2046
D) 30
- 7. What type of network cable would you use between a terminal and a console port?
A) CAT 1000E
B) patch over
C) cross-over
D) rollover
- 8. Which device would you use to create or divide broadcast domains?
A) gateway
B) switch
C) hub
D) bridge
- 9. The 3 types of connectors usually seen with Cisco's v.35 serial cables are the DB 60, Winchester 15 pin, and the ______ _______.
A) RJ 11
B) smart serial
C) DB 609
D) RJ 45
- 10. A common method for setting up a UTP Ethernet port to MDI or MDIX operation is to follow the cable color ________ association.
A) code
B) 568A and 568B
C) serialization
D) cabling
- 11. Routers are able to segment (partition) broadcast _________________.
A) collisions
B) servers
C) technologies
D) domains
- 12. Routers are able to interconnect different ________________ technologies.
A) server
B) switching
C) network
D) Microsoft
- 13. Each interface on a router require a separate network or ________________.
A) server
B) domain
C) switch
D) subnet
- 14. To establish a console connection from a PC to a CISCO router, which cable wiring option would you use?
A) straight-through copper cable
B) rollover cable
C) V.35 supersized thin-net cable
D) cross-over copper cable
- 15. Cabling that extended from one telecommunications room to another, would tend to be __________________ cabling.
A) acute
B) transversal
C) vertical
D) horizontal
- 16. Cabling that extended from the telecommunications room to the work area, would tend to be _____________________ cabling.
A) acute
B) horizontal
C) vertical
D) transversal
- 17. At a work area, you would tend to find what type of cabling?
A) segmented
B) patch
C) vertical
D) plenum-rated
|