ThatQuiz
|
Test Library
|
Take this test now
S3 Clock tools Homework - Quiz
s homework pic tools
  • 1. Which tool was used to Mark lines at 90 degrees (Right angle) to the edge of the wood?
A) Tri-Square
B) Marking Gauge
C) Steel Rule
  • 2. What kind of saw is tool “D” ?
A) Mitre Saw
B) Cross Cut Saw
C) Tenon Saw
D) Hack Saw
s homework pic tools
  • 3. Which tool did you use to measure the sizes of the joints?
A) Protractor
B) Marking Gauge
C) Steel Rule
D) Tri-Square
s homework pic tools
  • 4. Name the tool we used “E” to support the wood while sawing.
A) Vice Guard
B) Block Board
C) Bench Hook
D) Holding Bracket
s homework pic tools
  • 5. Which tool was best suited for marking lines parallel to the edge of the wood?
A) Marking Gauge
B) Scriber
C) Steel Rule
D) Tri-Square
s homework pic tools
  • 6. Tool “F” was used to remove scrap wood from our joints. What is it called?
A) Bevel Edged chisel
B) Mortise Gauge
C) Hand Scraper
D) Rough Cut File
hwork plane
  • 7. We used this tool to chamfer some of the clock parts. What is it called?
A) Router
B) Finisher
C) Smoother
D) Jack Plane
Hwork glue
  • 8. We used this Glue to assemble the clock. What type of glue is it?
A) Super Glue
B) Contact Adhesive
C) Epoxy Resin
D) P.V.A.
Hwork sander
  • 9. We finished a few parts of our clock on the Band facer.. Give a safety rule that we used here.
A) Wear safety gloves
B) Goggles were worn.
C) Keep away from water.
D) Hard hat required.
Hwork chiselling
  • 10. When we were cutting our joints as shown in the photo, what safety rule were we folhighing?
A) Use a heavy mallet.
B) Both hands behind the cutting edge of the chisel.
C) Must wear safety goggles.
D) Strike the chisel heavily.
Created with That Quiz — a math test site for students of all grade levels.