A) Left Button B) Center Button C) Right Button D) Top Button
A) USB and PC Ports B) Numbers 1, 2, 3, and 4 C) Letters A, B, C, and D D) Numerals I, II, III, and IV
A) USB and PC Ports B) Numbers 1, 2, 3, and 4 C) Numerals I, II, III, and IV D) Letters A, B, C, and D
A) Press the Back button until a Shut Down dialog box appears, then selecting the check with the Center button B) Insert the Shut Down USB adapter into the USB port on the side of the EV3 C) Remove the rechargable Li-Ion battery pack D) Press and hold the Left and Right buttons for 5 seconds
A) Use the Sound sensor and the built-in voice commands B) Use the LEGO IR remote C) Use the direction buttons to navigate, Center button to select, and Back button to cancel or go back. D) Touch the screen with an included stylus pen
A) File Navigation (second tab) > Select the Project > Select the Program B) Brick Apps (third tab) > Port View > Select the motor or sensor that you just recently used to run that program C) Settings (fourth tab) > Brick Info > Recently Run, then use the center button to select D) Run Recent (first tab) > Select the program then press the center button
A) Settings (fourth tab) > Brick Info > Projects, then use the center button to select the programs B) Run Recent (first tab) > Select the program then press the center button C) Brick Apps (third tab) > Port View > Select the project that is linked to available sensors and motors D) File Navigation (second tab) > Select the Project > Select the Program
A) Using the Brick Apps (third menu) > Port View > Select the motor or sensor you want to view B) Attaching a second screen adapter to the USB Port on the side of the EV3 C) Adding a block to display the motor/sensor value when running a program
A) On the back of the EV3 B) On the EV3 Software C) In the Settings (fourth tab) menu D) Behind the battery pack
A) In the Robot Educator section of the EV3 Education Programming Software B) In the EV3's firmware menus C) In the printed manual that came with the EV3 Set
A) Ethernet cable B) Power cable C) USB cable
A) Provide power to onboard electronics B) Create a physical effect like turning a wheel C) Process data and make decisions
A) Recent programs and settings B) User guide and Robot educator C) Canvas, palette and communication pane
A) Flow blocks B) Action blocks C) My blocks D) Advanced blocks
A) My blocks B) Flow blocks C) Advanced blocks D) Action blocks
A) they can be on, off, on for seconds, on for rotations, on for degrees B) end with a coast or brake C) positive power rotates motor clockwise/negative power rotates motor counter clockwise D) all of the listed attributes
A) Controls both motors together B) Controls both motors separately
A) When the program was last saved B) How far the eV3 has traveled C) What sensors and motors are attached and their current readings D) What is the current firmware version
A) Return the last input and output settings to the software B) Switch from program control to remote control C) Download and run the program
A) Enter a name and press the Go >>> button B) Click the + tab near the top of the screen C) Press the New Program button on the home screen |