A) Pyrolytic decomposition B) Thermal equilibrium C) Spontaneous heating D) Fire
A) Heat, Fuel, and Chemical Chain Reaction B) Fuel, Oxygen, and Carbon Dioxide C) Ignition, Fuel, and Nitrogen D) Heat, Fuel, and Oxygen
A) Pyrolytic vapor pressure B) Uninhibited chemical chain reaction C) Latent heat of vaporization D) Ambient atmospheric pressure
A) At least 10% B) At least 5% C) At least 25% D) At least 16%
A) Oxidation B) Pyrolysis C) Sublimation D) Vaporization
A) Boiling point B) Fire point C) Auto-ignition temperature D) Flash point
A) Fire point B) Critical temperature C) Flash point D) Kindling point
A) Advection B) Conduction C) Radiation D) Convection
A) Radiation B) Convection C) Diffusion D) Conduction
A) Convection B) Radiation C) Sublimation D) Conduction
A) Flammable range B) Flash point C) Vapor density D) Specific gravity
A) Near the ceiling B) Near the floor or in low-lying areas C) Exclusively outside the structure D) Evenly throughout the room
A) Viscosity B) Relative humidity C) Specific gravity D) Vapor density
A) Pyrolytic threshold B) Flammable or explosive range ( C) Flash zone D) Stoichiometric gap
A) Exactly at the stoichiometric point B) Above the auto-ignition temperature C) Below the Lower Explosive Limit D) Above the Upper Explosive Limit (UEL)
A) Detonation B) Flaming combustion C) Deflagration D) Smoldering (glowing) combustion
A) Detonation B) Backdraft C) Flashover D) Deflagration
A) Detonation B) Hypergolic reaction C) Deflagration D) Spontaneous combustion
A) Hydrogen cyanide (HCN) B) Carbon dioxide (CO2) C) Carbon monoxide (CO) D) Sulfur dioxide (SO2)
A) Helium B) Methane C) Hydrogen cyanide (HCN) D) Nitrous oxide
A) Joule B) British Thermal Unit (BTU) C) Watt D) Calorie
A) Piloted ignition B) Sympathetic detonation C) Spontaneous combustion D) Thermal runaway
A) Distilled water B) Mineral oil C) Linseed oil D) Silicone lubricant
A) Flame B) Ash C) Ember D) Soot
A) Incipient (Ignition) stage B) Decay (Smoldering) stage C) Fully developed stage D) Free-burning (Growth) stage
A) Boilover B) Rollover C) Backdraft D) Flashover
A) Backdraft B) Slopover C) BLEVE D) Flashover
A) Thick, yellowish-gray smoke puffing out of cracks and smoke-stained windows pulsating B) Rapidly cooling floor temperatures C) Clear blue flames licking across the ceiling D) Bright white smoke rising straight up
A) Rollover (Flameover B) Backdraft C) Flash point D) Boilover
A) Bi-level Liquid Expansion Vapor Energy B) Boiling Liquid Expanding Vapor Explosion C) Basic Liquid Explosive Ventilation Event D) Burning Liquid Evaporating Vapor Emission
A) Ordinary combustibles such as wood, paper, cloth, and plastics B) Energized electrical equipment C) Flammable liquids and gases D) Combustible metals
A) Ordinary solid combustibles B) Cooking oils and animal fats C) Flammable and combustible liquids, greases, and gases D) Energized electrical wiring
A) Combustible metals like magnesium and titanium B) Wood and paper products C) Energized electrical equipment D) Commercial kitchen cooking oils
A) Energized transformers B) Dry vegetation C) Combustible metals such as magnesium, titanium, sodium, and potassium D) Flammable liquids like gasoline
A) Vegetable oils, animal fats, and grease in commercial cooking appliances B) Kerosene and jet fuel C) Cardboard and packaging materials D) Potassium and sodium metals
A) Starvation B) Chemical inhibition C) Cooling D) Smothering
A) Starvation B) Smothering C) Cooling D) Atomization
A) Cooling B) Smothering C) Saponification D) Starvation(Fuel removal)
A) By drastically lowering the freezing point of fuel B) By interrupting the chemical chain reaction C) By creating an airtight metal seal D) By absorbing all ambient nitrogen
A) Saponification (forming a soapy foam blanket) B) Sublimation C) Hydrogenation D) Polymerization
A) Water causes the metal to freeze instantly B) Water turns into dry chemical powder C) Water conducts static electricity into the metal D) Water reacts violently with burning metals, releasing explosive hydrogen gas
A) Pull, Aim, Squeeze, Sweep B) Pull, Alert, Smother, Step back C) Press, Aim, Shake, Sweep D) Point, Activate, Spray, Stop
A) Silver or Red (with green triangle symbol) B) Blue (with circle symbol) C) Yellow (with star symbol) D) Black (with hexagon symbol)
A) Interrupting the chemical chain reaction via halogens B) Creating a permanent soapy foam layer C) Displacing oxygen (smothering) and providing minor cooling D) Absorbing fuel vapors chemically
A) Dry pipe system B) Deluge system C) Wet pipe system D) Pre-action system
A) Dry pipe system B) Standpipe system C) Wet pipe system D) Deluge system
A) Fusible link or frangible glass bulb B) Bimetallic circuit breaker C) Ionization chamber D) Photoelectric sensor
A) Flame flicker detector B) Rate-of-rise heat detector C) Photoelectric smoke detector D) Ionization smoke detector
A) Fixed-temperature heat detector B) Photoelectric smoke detector C) Fusible link detector D) Ionization smoke detector
A) Presidential Decree No. 1613 B) Republic Act No. 6975 C) Republic Act No. 9514 D) Presidential Decree No. 1185
A) Presidential Decree No. 1613 B) Republic Act No. 9263 C) Act No. 3815 D) Presidential Decree No. 1185
A) Philippine National Police (PNP) B) National Bureau of Investigation (NBI) C) Bureau of Fire Protection (BFP) D) Office of Civil Defense (OCD)
A) Republic Act No. 11589 B) Republic Act No. 6975 (DILG Act of 1990) C) Republic Act No. 8551 D) Republic Act No. 9263
A) Republic Act No. 9263 B) Republic Act No. 11589 C) Republic Act No. 11200 D) Republic Act No. 9514
A) Fire Safety Evaluation Clearance (FSEC) B) Fire Safety Inspection Certificate (FSIC) C) Occupancy Clearance Certificate D) Fire Hazard Abatement Order
A) Fire Safety Inspection Certificate (FSIC) B) Notice to Comply C) Fire Safety Evaluation Clearance (FSEC) D) Stoppage of Operations Order
A) 90 days B) 24 hours C) Not exceeding 15 days D) 60 days
A) Writ of Replevin B) Abatement Order / Closure Order C) Notice of Delinquency D) Administrative Fine Waiver
A) Republic Act No. 9514 B) Presidential Decree No. 1613 C) Presidential Decree No. 1185 D) Republic Act No. 7659
A) Burning grass in an open field with a permit B) Maliciously burning the property of another C) Operating a business without an FSIC D) Accidentally starting a fire through negligence
A) Never, because an owner has absolute right to destroy their property B) Only when the property is insured for more than one million pesos C) When done with intent to defraud or cause damage to another, or when the property is located in an inhabited place D) Only when committed during nighttime
A) Burning an abandoned wooden shed in a remote forest B) Burning any building where people usually gather, such as a church, school, hospital, or theater C) Burning a pile of dried leaves in a vacant lot D) Burning a broken wooden chair in a backyard
A) The fire started in the kitchen during dinner hours B) The building was equipped with working smoke detectors C) The fire department arrived within five minutes D) Substantial amounts of flammable substances or materials not normally kept in the building are found inside
A) The building had zero financial debts or mortgages B) The building or property is insured for substantially more than its actual value at the time of the fire C) The owner recently installed a new sprinkler system D) The fire occurred during a heavy typhoon
A) Frustrated Arson B) Consummated Arson C) Attempted Arson (or Proposal/Conspiracy to commit arson depending on overt acts) D) No crime is committed until smoke appears
A) Only when smoke enters the building without charring any material B) The moment any part of the building or structure is burned or charred, however slightly C) Only when the roof collapses completely D) Only when at least 50% of the building is destroyed
A) Yes, whenever insurance proceeds are not yet paid B) Yes, whenever the fire is extinguished before 10 minutes C) No; the moment a fire starts to burn the structure it is consummated, and if it fails to burn any part, it is merely attempted D) Yes, whenever no one dies in the fire
A) committed with intent to gain, for the benefit of another, or motivated by spite or hatred B) If committed during daytime C) If committed by a first-time offender D) If committed using matches instead of a lighter
A) Negligent Manslaughter B) Simple Physical Injuries C) Reckless Imprudence Resulting in Homicide D) Arson with Homicide / Murder (complex or absorbed depending on intent, governed by Art. 320/PD 1613)
A) Barangay Tanod Fire Brigade B) Municipal Fire Station Investigator C) Provincial Police Office D) Arson Investigation Division – National Headquarters (AID-NHQ)
A) Reckless Imprudence Resulting in Damage to Property (not intentional Arson) B) Simple Arson C) Malicious Mischief D) Destructive Arson
A) Notice to Comply (NTC) B) Building Permit Clearance C) Fire Safety Inspection Certificate (FSIC) D) Spot Investigation Report (SIR)
A) Fire Hydrant Inventory Report B) Preliminary Alarm Log C) Final Investigation Report (FIR) D) Daily Attendance Roster
A) Fire Safety Evaluation Clearance (FSEC) B) Occupancy Permit C) Fire Clearance Certificate (FCC) ( D) Sanitary Permit
A) To determine the Area of Origin and the Cause of the fire using the Scientific Method B) To immediately arrest the building owner C) To clear debris as fast as possible before taking photos D) To estimate the architectural value of undamaged adjacent lots
A) Randomly across all rooms simultaneously B) From the area of heaviest damage to the exterior C) From the exterior to the interior, and from the area of least damage to the area of heaviest damage D) Directly starting at the roof and moving downward
A) U-pattern B) Hourglass pattern C) Pointer pattern D) V-pattern
A) Spalling B) Calcination C) Alligatoring D) Crazing
A) Spalling B) Alligatoring (Char pattern) C) Ghosting D) Saddle burn
A) Yes, it only happens when kerosene is poured B) No; NFPA 921 establishes that char appearance alone cannot determine accelerant use without laboratory analysis C) Yes, it is 100% conclusive proof of gasoline D) No, because wood never chars in structural fires
A) Spalling B) Soot deposition C) Crazing D) Annealed melting
A) Polymerization B) Carbonization C) Sublimation D) Calcination
A) Saddle burn B) Clean burn C) Line of demarcation D) Rainbow sheen
A) A wall that was never exposed to smoke B) A stain left by unburned diesel fuel C) A wall washed with water by firefighters D) An area where intense heat has burned away previously deposited soot, leaving a bare, clean patch
A) Incendiary (intentional) fire B) Spontaneous heating C) Natural lightning strike D) Accidental electrical short circuit
A) A smoke plume drifting downwind B) A vehicle parked outside the burning warehouse C) A fire hose dragged by firefighters D) A stream of flammable liquid, paper, or cloth laid out to spread fire from one area to another
A) A municipal water pumping station B) hidden surveillance camera C) Potted vegetation inside a house D) The preparation and placement of combustible materials around an ignition device to ensure fire growth
A) Paper grocery bags B) Cardboard boxes C) Unsealed plastic Ziploc bags D) Clean, airtight, unlined metal paint cans or specialized vapor-tight nylon/polyester bags
A) Plastic bags block X-ray scanners B) Plastic bags weigh too much for laboratory scales C) Plastic bags dissolve immediately upon touching cold ash D) Hydrocarbon vapors permeate through standard plastic and react with the bag material, contaminating or losing the sample
A) Thin-Layer Chromatography (TLC) B) Atomic Absorption Spectroscopy (AAS) C) Gas Chromatography–Mass Spectrometry (GC-MS) D) Polymerase Chain Reaction (PCR)
A) To measure the color of the room's interior B) To sell the carpet to recover damages C) To rule out background hydrocarbons naturally present in adhesives, glues, or synthetic carpet fibers D) To test if the carpet is waterproof
A) Complex corporate insurance fraud B) Political terrorism C) Concealing white-collar embezzlement D) Curiosity, thrill-seeking, or psychological compulsion (pyromania)
A) Pyromania B) Vandalism by teenagers C) Financial gain, such as collecting fraudulent insurance claims or eliminating business competitors D) Domestic jealousy
A) Crime concealment (destroying physical evidence) B) Revenge or spite C) Pyromania D) Extortion
A) Arcing / Beading (localized sharp demarcation between melted bead and unmelted wire) B) Annealing C) Electroplating D) Galvanization
A) To serve as an architectural blueprint for future tenants B) To estimate the cost of rebuilding the structure C) To replace all photographic documentation D) To document exact measurements, spatial relationships, burn patterns, and locations of collected physical evidence
A) Corpus Delicti B) Chain of Custody C) Fruit of the Poisonous Tree D) Res Ipsa Loquitur
A) Proof of the suspect's confession alone B) Proof that a burning occurred and proof that it was caused by a criminal/incendiary agency rather than natural or accidental causes C) Proof that the suspect owned a lighter D) Proof that the building was completely reduced to ashes
A) Miranda v. Arizona B) Michigan v. Tyler C) Mapp v. Ohio D) Terry v. Ohio
A) By converting the liquid into water via chemical neutralization B) By absorbing all atmospheric nitrogen in the surrounding room C) By breaking the chain reaction and smothering the fuel surface D) By instantly freezing the liquid fuel below its freezing point |