S3 Clock tools Homework - Quiz
- 1. Which tool was used to Mark lines at 90 degrees (Right angle) to the edge of the wood?
A) Steel Rule
B) Marking Gauge
C) Tri-Square
- 2. What kind of saw is tool “D” ?
A) Cross Cut Saw
B) Mitre Saw
C) Hack Saw
D) Tenon Saw
- 3. Which tool did you use to measure the sizes of the joints?
A) Protractor
B) Marking Gauge
C) Steel Rule
D) Tri-Square
- 4. Name the tool we used “E” to support the wood while sawing.
A) Block Board
B) Vice Guard
C) Holding Bracket
D) Bench Hook
- 5. Which tool was best suited for marking lines parallel to the edge of the wood?
A) Scriber
B) Marking Gauge
C) Steel Rule
D) Tri-Square
- 6. Tool “F” was used to remove scrap wood from our joints. What is it called?
A) Hand Scraper
B) Mortise Gauge
C) Bevel Edged chisel
D) Rough Cut File
- 7. We used this tool to chamfer some of the clock parts. What is it called?
A) Router
B) Smoother
C) Finisher
D) Jack Plane
- 8. We used this Glue to assemble the clock. What type of glue is it?
A) Super Glue
B) Epoxy Resin
C) Contact Adhesive
D) P.V.A.
- 9. We finished a few parts of our clock on the Band facer.. Give a safety rule that we used here.
A) Keep away from water.
B) Goggles were worn.
C) Hard hat required.
D) Wear safety gloves
- 10. When we were cutting our joints as shown in the photo, what safety rule were we folhighing?
A) Use a heavy mallet.
B) Strike the chisel heavily.
C) Both hands behind the cutting edge of the chisel.
D) Must wear safety goggles.
|