- 1. 1. The following are major components of lathe machines
A) Tailstock
B) Wool
C) Carriage
D) Headstock
- 2. 2. Which of the following is not in the category of operations that are commonly performed on the lathe machines?
A) Turning
B) Cutting
C) Steaming
D) Facing
- 3. 3. The operation that is used to produce flat surfaces on lathe machines is called ----------
A) Drilling
B) Turning
C) Knurling
D) Facing
- 4. 4. An operation which involves cutting threads on a workpiece is known as --------
A) Screw cutting
B) Pain cutting
C) Deep cutting
D) Lateral cutting
- 5. 5. Which of the following machines is most suitable for marking holes in a workpiece?
A) Mill press
B) Forge press
C) Air press
D) Drill press
- 6. 6. The following are types of grinding machines except ----------
A) Plain grinder
B) Belt grinder
C) Bench grinder
D) Surface grinder
- 7. 7. The coolant which helps to reduce distortion, power consumption, improve surface finish and protects against corrosion of the workpiece is called ----
A) Sprinkler fluids
B) Grinding powder
C) Cutting fluid
D) Milling gas
- 8. 8. The machine that can be used to cut workpieces with coarse tooth hacksaw blades is called ------
A) Chamfering machine
B) Power sawing machine
C) Screw machine
D) Turning machine
- 9. 9. Forging can be classified into the following except.....
A) Warm forging
B) Cloudy forging
C) Cold forging
D) Hot forging
- 10. 10. The types of folding machines include the following except -----
A) Paper folder
B) Knot folder
C) Knife folder
D) Buckle folder
- 11. 11. The series of operations that transform industrial materials from a raw material state into a finished product state is called
A) Quarter sawn
B) Feller bunching
C) Pre-cut
D) Material processing
- 12. 12. The key concept of timber processing includes the following except -------
A) Conversion
B) Growth and felling
C) Treatability
D) Seasoning
- 13. 13. One of the following is not a process in timber felling.
A) Skidding
B) Limbing
C) Bucking
D) Knitting
- 14. 14. ------ and ------ are the two methods of timber seasoning
A) Plain and quarter seasoning
B) Natural and artificial seasoning
C) Limbing and skidding seasoning
D) Limbing and bucking seasoning
- 15. 15. In the conversion of timber, the method that produces radial boards and far more expensive than the tangential timber because of the need to double handle the log is known as --------
A) Curved sawn
B) Plain and edge sawn
C) Through and through sawn
D) Quarter sawn
- 16. 16. Drying process that involves the introduction of heat is ------
A) Hot drying
B) Kiln drying
C) Solar Energy drying
D) Temperate drying
- 17. 17. The most common treatment process is known as -----
A) Pressure treatment
B) Temple treatment
C) Deliberate treatment
D) Temperature treatment
- 18. 18. One of the following is not a preservative for timber.
A) Light organic solvent-borne preservatives
B) Folder treatment
C) waterborne preservatives
D) Envelope treatment
- 19. 19. Defects due to insects and other animals include the following except ----------
A) Insects
B) Birds and mammals
C) Warping
D) Marine borer
- 20. 20. One of the following is not a defect due to conversion.
A) Machine notches
B) Case hardening
C) Miscut
D) Boxed heart
|