A) Thermal equilibrium B) Fire C) Pyrolytic decomposition D) Spontaneous heating
A) Heat, Fuel, and Oxygen B) Heat, Fuel, and Chemical Chain Reaction C) Ignition, Fuel, and Nitrogen D) Fuel, Oxygen, and Carbon Dioxide
A) Pyrolytic vapor pressure B) Ambient atmospheric pressure C) Uninhibited chemical chain reaction D) Latent heat of vaporization
A) At least 16% B) At least 10% C) At least 5% D) At least 25%
A) Sublimation B) Pyrolysis C) Oxidation D) Vaporization
A) Boiling point B) Auto-ignition temperature C) Flash point D) Fire point
A) Critical temperature B) Kindling point C) Fire point D) Flash point
A) Radiation B) Convection C) Advection D) Conduction
A) Diffusion B) Convection C) Radiation D) Conduction
A) Convection B) Sublimation C) Radiation D) Conduction
A) Specific gravity B) Flammable range C) Flash point D) Vapor density
A) Near the floor or in low-lying areas B) Evenly throughout the room C) Near the ceiling D) Exclusively outside the structure
A) Viscosity B) Relative humidity C) Vapor density D) Specific gravity
A) Flash zone B) Pyrolytic threshold C) Stoichiometric gap D) Flammable or explosive range (
A) Below the Lower Explosive Limit B) Above the auto-ignition temperature C) Above the Upper Explosive Limit (UEL) D) Exactly at the stoichiometric point
A) Detonation B) Smoldering (glowing) combustion C) Flaming combustion D) Deflagration
A) Detonation B) Flashover C) Backdraft D) Deflagration
A) Spontaneous combustion B) Hypergolic reaction C) Detonation D) Deflagration
A) Hydrogen cyanide (HCN) B) Carbon monoxide (CO) C) Sulfur dioxide (SO2) D) Carbon dioxide (CO2)
A) Helium B) Methane C) Nitrous oxide D) Hydrogen cyanide (HCN)
A) British Thermal Unit (BTU) B) Watt C) Calorie D) Joule
A) Sympathetic detonation B) Piloted ignition C) Spontaneous combustion D) Thermal runaway
A) Silicone lubricant B) Linseed oil C) Distilled water D) Mineral oil
A) Ash B) Flame C) Soot D) Ember
A) Free-burning (Growth) stage B) Incipient (Ignition) stage C) Fully developed stage D) Decay (Smoldering) stage
A) Rollover B) Flashover C) Boilover D) Backdraft
A) Slopover B) BLEVE C) Flashover D) Backdraft
A) Clear blue flames licking across the ceiling B) Bright white smoke rising straight up C) Rapidly cooling floor temperatures D) Thick, yellowish-gray smoke puffing out of cracks and smoke-stained windows pulsating
A) Backdraft B) Flash point C) Rollover (Flameover D) Boilover
A) Burning Liquid Evaporating Vapor Emission B) Boiling Liquid Expanding Vapor Explosion C) Basic Liquid Explosive Ventilation Event D) Bi-level Liquid Expansion Vapor Energy
A) Energized electrical equipment B) Ordinary combustibles such as wood, paper, cloth, and plastics C) Combustible metals D) Flammable liquids and gases
A) Flammable and combustible liquids, greases, and gases B) Ordinary solid combustibles C) Energized electrical wiring D) Cooking oils and animal fats
A) Wood and paper products B) Combustible metals like magnesium and titanium C) Energized electrical equipment D) Commercial kitchen cooking oils
A) Flammable liquids like gasoline B) Combustible metals such as magnesium, titanium, sodium, and potassium C) Dry vegetation D) Energized transformers
A) Cardboard and packaging materials B) Potassium and sodium metals C) Kerosene and jet fuel D) Vegetable oils, animal fats, and grease in commercial cooking appliances
A) Chemical inhibition B) Cooling C) Smothering D) Starvation
A) Atomization B) Cooling C) Starvation D) Smothering
A) Saponification B) Smothering C) Cooling D) Starvation(Fuel removal)
A) By absorbing all ambient nitrogen B) By interrupting the chemical chain reaction C) By creating an airtight metal seal D) By drastically lowering the freezing point of fuel
A) Saponification (forming a soapy foam blanket) B) Polymerization C) Hydrogenation D) Sublimation
A) Water reacts violently with burning metals, releasing explosive hydrogen gas B) Water causes the metal to freeze instantly C) Water turns into dry chemical powder D) Water conducts static electricity into the metal
A) Pull, Alert, Smother, Step back B) Press, Aim, Shake, Sweep C) Pull, Aim, Squeeze, Sweep D) Point, Activate, Spray, Stop
A) Black (with hexagon symbol) B) Blue (with circle symbol) C) Silver or Red (with green triangle symbol) D) Yellow (with star symbol)
A) Absorbing fuel vapors chemically B) Interrupting the chemical chain reaction via halogens C) Displacing oxygen (smothering) and providing minor cooling D) Creating a permanent soapy foam layer
A) Dry pipe system B) Wet pipe system C) Pre-action system D) Deluge system
A) Wet pipe system B) Deluge system C) Dry pipe system D) Standpipe system
A) Ionization chamber B) Photoelectric sensor C) Bimetallic circuit breaker D) Fusible link or frangible glass bulb
A) Ionization smoke detector B) Rate-of-rise heat detector C) Photoelectric smoke detector D) Flame flicker detector
A) Fixed-temperature heat detector B) Fusible link detector C) Ionization smoke detector D) Photoelectric smoke detector
A) Presidential Decree No. 1613 B) Presidential Decree No. 1185 C) Republic Act No. 9514 D) Republic Act No. 6975
A) Presidential Decree No. 1613 B) Act No. 3815 C) Presidential Decree No. 1185 D) Republic Act No. 9263
A) Philippine National Police (PNP) B) National Bureau of Investigation (NBI) C) Bureau of Fire Protection (BFP) D) Office of Civil Defense (OCD)
A) Republic Act No. 8551 B) Republic Act No. 9263 C) Republic Act No. 11589 D) Republic Act No. 6975 (DILG Act of 1990)
A) Republic Act No. 11589 B) Republic Act No. 11200 C) Republic Act No. 9514 D) Republic Act No. 9263
A) Occupancy Clearance Certificate B) Fire Safety Inspection Certificate (FSIC) C) Fire Safety Evaluation Clearance (FSEC) D) Fire Hazard Abatement Order
A) Fire Safety Inspection Certificate (FSIC) B) Notice to Comply C) Stoppage of Operations Order D) Fire Safety Evaluation Clearance (FSEC)
A) 60 days B) 90 days C) Not exceeding 15 days D) 24 hours
A) Notice of Delinquency B) Administrative Fine Waiver C) Abatement Order / Closure Order D) Writ of Replevin
A) Presidential Decree No. 1613 B) Presidential Decree No. 1185 C) Republic Act No. 9514 D) Republic Act No. 7659
A) Maliciously burning the property of another B) Burning grass in an open field with a permit C) Accidentally starting a fire through negligence D) Operating a business without an FSIC
A) When done with intent to defraud or cause damage to another, or when the property is located in an inhabited place B) Only when committed during nighttime C) Only when the property is insured for more than one million pesos D) Never, because an owner has absolute right to destroy their property
A) Burning a broken wooden chair in a backyard B) Burning a pile of dried leaves in a vacant lot C) Burning an abandoned wooden shed in a remote forest D) Burning any building where people usually gather, such as a church, school, hospital, or theater
A) Substantial amounts of flammable substances or materials not normally kept in the building are found inside B) The building was equipped with working smoke detectors C) The fire department arrived within five minutes D) The fire started in the kitchen during dinner hours
A) The building or property is insured for substantially more than its actual value at the time of the fire B) The building had zero financial debts or mortgages C) The fire occurred during a heavy typhoon D) The owner recently installed a new sprinkler system
A) Consummated Arson B) Frustrated Arson C) Attempted Arson (or Proposal/Conspiracy to commit arson depending on overt acts) D) No crime is committed until smoke appears
A) The moment any part of the building or structure is burned or charred, however slightly B) Only when at least 50% of the building is destroyed C) Only when smoke enters the building without charring any material D) Only when the roof collapses completely
A) Yes, whenever the fire is extinguished before 10 minutes B) No; the moment a fire starts to burn the structure it is consummated, and if it fails to burn any part, it is merely attempted C) Yes, whenever no one dies in the fire D) Yes, whenever insurance proceeds are not yet paid
A) committed with intent to gain, for the benefit of another, or motivated by spite or hatred B) If committed by a first-time offender C) If committed during daytime D) If committed using matches instead of a lighter
A) Arson with Homicide / Murder (complex or absorbed depending on intent, governed by Art. 320/PD 1613) B) Simple Physical Injuries C) Reckless Imprudence Resulting in Homicide D) Negligent Manslaughter
A) Arson Investigation Division – National Headquarters (AID-NHQ) B) Barangay Tanod Fire Brigade C) Municipal Fire Station Investigator D) Provincial Police Office
A) Malicious Mischief B) Reckless Imprudence Resulting in Damage to Property (not intentional Arson) C) Destructive Arson D) Simple Arson
A) Fire Safety Inspection Certificate (FSIC) B) Building Permit Clearance C) Notice to Comply (NTC) D) Spot Investigation Report (SIR)
A) Daily Attendance Roster B) Preliminary Alarm Log C) Final Investigation Report (FIR) D) Fire Hydrant Inventory Report
A) Sanitary Permit B) Fire Clearance Certificate (FCC) ( C) Occupancy Permit D) Fire Safety Evaluation Clearance (FSEC)
A) To estimate the architectural value of undamaged adjacent lots B) To determine the Area of Origin and the Cause of the fire using the Scientific Method C) To immediately arrest the building owner D) To clear debris as fast as possible before taking photos
A) From the exterior to the interior, and from the area of least damage to the area of heaviest damage B) From the area of heaviest damage to the exterior C) Randomly across all rooms simultaneously D) Directly starting at the roof and moving downward
A) U-pattern B) Hourglass pattern C) V-pattern D) Pointer pattern
A) Spalling B) Calcination C) Alligatoring D) Crazing
A) Spalling B) Saddle burn C) Alligatoring (Char pattern) D) Ghosting
A) No; NFPA 921 establishes that char appearance alone cannot determine accelerant use without laboratory analysis B) Yes, it is 100% conclusive proof of gasoline C) Yes, it only happens when kerosene is poured D) No, because wood never chars in structural fires
A) Annealed melting B) Crazing C) Spalling D) Soot deposition
A) Polymerization B) Calcination C) Carbonization D) Sublimation
A) Saddle burn B) Line of demarcation C) Clean burn D) Rainbow sheen
A) A wall washed with water by firefighters B) An area where intense heat has burned away previously deposited soot, leaving a bare, clean patch C) A stain left by unburned diesel fuel D) A wall that was never exposed to smoke
A) Accidental electrical short circuit B) Incendiary (intentional) fire C) Spontaneous heating D) Natural lightning strike
A) A fire hose dragged by firefighters B) A vehicle parked outside the burning warehouse C) A smoke plume drifting downwind D) A stream of flammable liquid, paper, or cloth laid out to spread fire from one area to another
A) The preparation and placement of combustible materials around an ignition device to ensure fire growth B) Potted vegetation inside a house C) hidden surveillance camera D) A municipal water pumping station
A) Paper grocery bags B) Unsealed plastic Ziploc bags C) Clean, airtight, unlined metal paint cans or specialized vapor-tight nylon/polyester bags D) Cardboard boxes
A) Plastic bags block X-ray scanners B) Hydrocarbon vapors permeate through standard plastic and react with the bag material, contaminating or losing the sample C) Plastic bags weigh too much for laboratory scales D) Plastic bags dissolve immediately upon touching cold ash
A) Atomic Absorption Spectroscopy (AAS) B) Thin-Layer Chromatography (TLC) C) Gas Chromatography–Mass Spectrometry (GC-MS) D) Polymerase Chain Reaction (PCR)
A) To sell the carpet to recover damages B) To test if the carpet is waterproof C) To rule out background hydrocarbons naturally present in adhesives, glues, or synthetic carpet fibers D) To measure the color of the room's interior
A) Concealing white-collar embezzlement B) Curiosity, thrill-seeking, or psychological compulsion (pyromania) C) Political terrorism D) Complex corporate insurance fraud
A) Financial gain, such as collecting fraudulent insurance claims or eliminating business competitors B) Domestic jealousy C) Vandalism by teenagers D) Pyromania
A) Pyromania B) Revenge or spite C) Crime concealment (destroying physical evidence) D) Extortion
A) Arcing / Beading (localized sharp demarcation between melted bead and unmelted wire) B) Electroplating C) Annealing D) Galvanization
A) To document exact measurements, spatial relationships, burn patterns, and locations of collected physical evidence B) To serve as an architectural blueprint for future tenants C) To estimate the cost of rebuilding the structure D) To replace all photographic documentation
A) Corpus Delicti B) Chain of Custody C) Fruit of the Poisonous Tree D) Res Ipsa Loquitur
A) Proof that a burning occurred and proof that it was caused by a criminal/incendiary agency rather than natural or accidental causes B) Proof that the suspect owned a lighter C) Proof that the building was completely reduced to ashes D) Proof of the suspect's confession alone
A) Miranda v. Arizona B) Mapp v. Ohio C) Michigan v. Tyler D) Terry v. Ohio
A) By absorbing all atmospheric nitrogen in the surrounding room B) By instantly freezing the liquid fuel below its freezing point C) By breaking the chain reaction and smothering the fuel surface D) By converting the liquid into water via chemical neutralization |