| __ | 1. | Build Platform | | A. | The flat surface used by your Dremel to build objects |
| __ | 2. | Build Platform Clip | | B. | Located at the front of the platform to secure it in place |
| __ | 3. | Build Tape | | C. | Helps objects stick to the build plate |
| __ | 4. | Build Volume | | D. | Stops the extruder at the end of travel |
| __ | 5. | Door | | E. | 3D space an object takes up once it is built |
| __ | 6. | Extruder | | F. | Located on the front panel to allow access inside the Dremel |
| __ | 7. | Extruder fan | | G. | Located on the top to allow access to the Dremel |
| __ | 8. | Extruder Intake | | H. | Where filament is inserted for builds |
| __ | 9. | Lid | | I. | Cools the extruder and outer assembly |
| __ | 10. | Limit Switch | | J. | Uses gears and heat to push filament out |